Reset pin of M1-N1

The following elaborates Reset pin J3_1.5 - RESET input, of M1-N1

Reference: M1-N1-HW-Compatibility-Design-Guide

nReset is only needed to perform a hardware reset of the M1-N1 module. Nothing is needed on this pin to power-up M1-N1

Reset in SigDev

In Signetik Dev board J3_1.1, J3_2.1 are tied to Vin.

Please refer to the Dev board schematic details

The Dev board does not provide any signal on the nReset line by itself until jumper is installed on P3. ​

Default behavior

nRESET is pulled high by default. It should be driven low for 5uSec or longer to reset the module.